Filter
Top Products
8
44. Center the heat shrink tubing (2) over the solder joint and
heat using a heat gun. Heat the joint until the tubing is
tightly sealed and sealant (1) comes out of both ends of
the t ubing.
45. Place the lower B-pilla r trim panel (3) into position and
engage the retaining tabs that secure the trim panel to
the B-pillar (4).
46. Route the seat belt through the slot provided in the
B-pillar trim panel.
47. Install the bolt (2) that secures the seat belt (1) to the
bottom of the B-pillar (4).
48. Place the upper B-pillar trim p anel (5) into po sition and
engage the retaining tabs that secure the trim panel to
the B-pillar (4).
49. Install the bolt (2) that secures the seat belt (3) to the
top of the B-pillar (4) and Install the cap (1).
Aug 08, 2008 K6860631 Rev. 1