Filter
Top Products
5-11
Cisco Metro 1500 Series Hardware Installation Guide
78-10588-03
Chapter 5 Connecting Optical Cables
Connecting Local Lines to WCMs
Figure 5-7 Connecting Local Lines to a WCM
Step 3 Remove the dust cover from the MiniSC plug of the local transmission fiber and
clean the fiber as described in “Cleaning the Connectors” section on page 3-19.
Step 4 Remove the blind plug from the WCM connector labeled L/T. Connect the
cleaned plug to the open connector of the WCM, as shown in Figure 5-7.
Step 5 Place the fiber-optic cables in the cable holder of the primary chassis and
extension chassis and the rack at the side of both chassis.
Step 6 Mount the acrylic cover on the front of the chassis.
L/T
R/T
R/R
L/R
Loop
On/Err
L/T
R/T
R/R
L/R
39360
Direction of light
Local transmission fiber
Local receiver fiber