5-15
Cisco Metro 1500 Series Hardware Installation Guide
78-10588-03
Chapter 5 Connecting Optical Cables
Connecting Optical Isolators
Figure 5-10 Optical Isolator Connection Scenario
To connect the optical isolator, follow these guidelines:
• The optical connector coming out of a WCM is MUPC type. Cisco stocks
fiber jumpers that use an MU-to-SC type connection. This is the standard
jumper configuration. However, the isolator can be used with a number of
different connector types, if needed.
• The fiber jumper coming out of the WCM is connected to the fiber attached
to the optical isolator. For example, two SC connectors are connected.
• The fiber on the other side of the optical isolator is connected to the trunk or
remote fiber. For example, two SC connectors are connected.
L/T
R/T
R/R
L/R
Loop
On/Err
L/T
R/T
R/R
L/R
Card connector
(MiniSC)
Optical isolator Trunk connector
(ST of FC/PC or MiniSC)
Trunk or RSM
connectors
WCM
42292