Filter
Top Products
Chapter 5 Connecting Optical Cables
Connecting Remote Lines to a BSM
5-8
Cisco Metro 1500 Series Hardware Installation Guide
78-10588-03
Figure 5-5 Connecting Remote Lines to a BSM
Step 3 Remove the dust cover from the MiniSC plug of the remote receiver fiber line, and
clean the fiber as described in the “Cleaning the Connectors” section on
page 3-19.
Step 4 Remove the blind plug from the BSM connector labeled D. Connect the cleaned
plug to the open connector of the BSM, as shown in Figure 5-5.
Step 5 Place the fiber-optic cables in the cable holder of the primary and extension
chassis and the rack at the side of both chassis.
Note If you have an optional RSM installed, proceed to the “Connecting
Remote Lines to RSMs” section on page 5-9. Otherwise skip to the
“Connecting Local Lines to WCMs” section on page 5-10.
BSM
M1
D1
M2
D2
M3 D3
M4 D4
MD
Direction of light
39346
MD