Filter
Top Products
5-5
Cisco Metro 1500 Series Hardware Installation Guide
78-10588-03
Chapter 5 Connecting Optical Cables
Connecting BSMs with MUX and DMX Modules
Step 4 Remove the dust cover from the other end of the jumper and the blind plug from
the BSM connector labeled D1. (Use D1 if you are routing the DMX of the
primary chassis.) Connect the MiniSC plug to the open connector of the BSM, as
shown in Figure 5-3.
Figure 5-3 Connecting a BSM to a DMX
Step 5 Place the fiber-optic cables in the cable holder of the primary and extension
chassis and the rack at the side of both chassis.
Note If you have an RSM installed, proceed to the “Connecting a BSM to
an RSM” section on page 5-6. Otherwise skip to the “Connecting
Remote Lines to a BSM” section on page 5-7
1-8(32)
DMX
D1
nc
7
8
5
6
3
4
1
2
BSM
M1
D1
M2
D2
M3 D3
M4 D4
MD
39344
M
D1
nc