Cisco Systems 3545 Serial Network Card User Manual


 
CHAPTER
2-1
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.6
OL-17011-01
2
Installing the Cisco Unified
Videoconferencing 3545 Gateway
Physical Description, page 2-1
Requirements for Installation, page 2-3
Verifying the Package Contents, page 2-4
Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack, page 2-5
How to Install the Gateway, page 2-6
How to Perform the Initial Gateway Configuration, page 2-10
Connecting the Gateway to the Network, page 2-15
Connecting PRI Lines to the Gateway, page 2-15
Connecting Serial Lines to the Gateway, page 2-15
Serial Gateway Cable Connections and Pin-outs, page 2-16
Connecting the Gateway to a Power Source, page 2-27
Accessing the Gateway Administrator Interface, page 2-27
Online Help Registration, page 2-28
Physical Description
Gateway Module, page 2-1
Cisco Unified Videoconferencing 3545 PRI Gateway RTM, page 2-2
Cisco Unified Videoconferencing 3545 Serial Gateway RTM, page 2-3
Gateway Module
The gateway module has a 10/100BaseT Ethernet port on the front panel that uses an RJ-45 connector
to connect to the network. There is an asynchronous, 9-pin serial port that you can use with a
hyperterminal program to configure and monitor the module.
Figure 2-1 shows the front panel components of the gateway module. Table 2-1 describes these
components.