Filter
Top Products
27
Figure 27 Torquing the Terminal Block Plug Captive Screws
Caution Do not overtorque the terminal block plug captive screws. The recommended maximum torque is from 0.5 Nm
(4.425 lbf in.) to 0.6 Nm (5.310 lbf in.).
Step 7 Use a ratcheting torque screwdriver to torque the terminal block plug captive screw (above the installed wire lead) to
from 0.5 Nm (4.425 lbf in.) to 0.6 Nm (5.310 lbf in.), as shown in Figure 27.
Figure 28 Completed Wiring of Terminal Block Plug
Step 8 Repeat Step 6 and Step 7 for the remaining three DC-input power source wires. Figure 28 shows the completed wiring
of a terminal block plug.
1 Torque is from 0.5 Nm (4.425 lbf in.) to 0.6 Nm (5.310 lbf in.)
1 Negative (–) 3 Negative (–)
2 Return (+) 4 Return (+)
170974
1
170972
A
B
1
2
3
4