Cisco Systems 7505 Network Router User Manual


 
14
Flash Memory Cards
Install Field Replaceable Units (FRUs)
A
B
C
57301
EJECT
UP
EJECT
UP
EJECT
UP
A Flash memory card that ships with your Cisco
7505 contains the Cisco IOS software image to boot
your router. You do not need to format it.
The RSP has two PC Card slots—slot 0 and slot
1—into which you can install a Flash memory card.
PC Card slot 0 is on the top and slot 1 is on the
bottom.
Note A Flash memory card can be inserted and
removed with the system power on. Both PC Card
slots can be used at the same time.
Step 1 To eject the card, press the appropriate
eject button until the card is free of the
connector at the back of the slot.
Step 2 Remove the card from the slot and place it
in an antistatic bag to protect it.
Step 3 Face the front panel of the RSP, and hold
the Flash memory card with the connector
end of the card toward the slot.
Note The Flash memory card is keyed and cannot
be seated the wrong way. The eject button will not
pop out if the card is not properly inserted.
Step 4 Insert the card into the appropriate slot
until the card completely seats in the
connector at the back of the slot and the
eject button pops out toward you.
Note The card does not insert all the way inside the
RSP; a portion of the card remains outside of the
slot. Do not attempt to force the card past this point.