Filter
Top Products
5
Attach the Cable-Management Brackets
Install the Hardware
Bracket (2)
M3 screw (6)
53372
EJECT
SLOT 0
SLOT 1
NORMAL
CPU HALT
RESET
CONSOLE
ROUTE SWITCH PROCESSOR
Step 1 Place the bracket on the rear of the
chassis, as shown.
Step 2 Insert three M3 x 8-mm Phillips screws,
and tighten slightly with your finger.
Step 3 Use a Phillips Number 1 screwdriver to
tighten all three screws.
Step 4 Repeat Step 1 through Step 3 for the
second bracket.
Step 5 Route the interface cables through the
brackets.