Filter
Top Products
Configuring SVCs, PVCs, SoftPVCs, PVPs, and VPTunnels 3-5
Configuring the Router
Example
Router> enable
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface atm 0.1 multipoint
Router(config-subif)# ip address 193.153.185.33 255.255.255.224
Router(config-subif)# atm esi-address 999999888888.00
Router(config-subif)# end
Router#
Verify
Switch# show interface atm 0.1
ATM0.1 is up, line protocol is up
Hardware is ATMizer BX-50
Internet address is 193.153.185.33/27
MTU 4470 bytes, BW 155520 Kbit, DLY 100 usec, rely 255/255, load 1/255
NSAP address: 47.0091810000000061E5BC01.999999888888.00
Encapsulation ATM
Switch#
5
Router(config-subif)# atm
esi-address address
Configure a 14-digit ESI address on the
subinterface (for example,
111111222222.00).
After ILMI address registration is
complete, an NSAP address is
automatically created based on the ESI
address you entered.
6 Router(config-subif)# end
Router#
Return to privileged EXEC mode.
7 (No command.)
Repeat this procedure on the other router.
Step Command Purpose