Filter
Top Products
Configuring Tag Switching on an ATM Switch Router
ATMSwitch Router Quick Software Configuration Guide5-4
Configuring the Routing Protocol
Enable the routing protocol (OSPF) on the ATM switch router so that it can create routing
tables, which identify routes through the network. Then add the addresses and associated
routing areas to the routing process so that it can propagate the addresses to other ATM
switches and routers.
Take these steps:
Step Command Purpose
1 Switch(config)# router ospf
process_number
Enable the routing protocol and assign it a
process number. The process number is any
positive integer.
2 Switch(config-router)# network
address wildcard-mask area
area-id
Define the network prefix, a wildcard
subnet mask, and the associated area
number on which to run the routing
protocol. An area number is an
identification number for an address range.
Repeat this command for each additional
area you want to add to the routing process.
Caution Ethernet interface 0 on the
processor card (CPU card) is used for
system management only (for example,
downloading system images or
configuration files from a TFTP
1
server).
Do not add this interface to the routing
process.
1 TFTP = Trivial File Transfer Protocol
3 Switch(config-router)# exit
Switch(config)#
Return to global configuration mode.