Filter
Top Products
30-6
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 30 Configuring EIGRP
Customizing EIGRP
Step 12 Click OK.
Customizing EIGRP
This section describes how to customize the EIGRP routing and includes the following topics:
• Defining a Network for an EIGRP Routing Process, page 30-6
• Configuring Interfaces for EIGRP, page 30-7
• Configuring the Summary Aggregate Addresses on Interfaces, page 30-8
• Changing the Interface Delay Value, page 30-9
• Enabling EIGRP Authentication on an Interface, page 30-10
• Defining an EIGRP Neighbor, page 30-11
• Redistributing Routes Into EIGRP, page 30-11
• Filtering Networks in EIGRP, page 30-13
• Customizing the EIGRP Hello Interval and Hold Time, page 30-14
• Disabling Automatic Route Summarization, page 30-15
• Configuring Default Information in EIGRP, page 30-15
• Disabling EIGRP Split Horizon, page 30-16
• Restarting the EIGRP Process, page 30-17
Defining a Network for an EIGRP Routing Process
The Network table lets you specify the networks used by the EIGRP routing process. For an interface to
participate in EIGRP routing, it must fall within the range of addresses defined by the network entries.
For directly connected and static networks to be advertised, they must also fall within the range of the
network entries.
The Network table displays the networks configured for the EIGRP routing process. Each row of the
table displays the network address and associated mask configured for the specified EIGRP routing
process.
To add or define a network, perform the following steps:
Step 1 In the main ASDM window, choose Configuration > Device Setup > Routing > EIGRP > Setup.
The EIGRP Setup pane appears.
Step 2 Check the Enable EIGRP routing check box.
Step 3 In the EIGRP Process field, enter the autonomous system (AS) number for the EIGRP process. The AS
number can be from 1 to 65535.
Step 4 Click the Networks tab.
Step 5 Click Add to add a new network entry.
The Add EIGRP Network dialog box appears. To remove a network entry, choose the entry in the table
and click Delete.