Filter
Top Products
40-20
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 40 Configuring Management Access
Configuring AAA for System Administrators
• clear pager
• quit
• show version
If you move any configure mode commands to a lower level than 15, be sure to move the configure
command to that level as well, otherwise, the user will not be able to enter configuration mode.
To view all privilege levels, see the “Viewing Local Command Privilege Levels” section on page 40-23.
Configuring Authentication for CLI, ASDM, and enable command Access
To configure management authentication, perform the following steps:
Step 1 To authenticate users who use the enable command, choose Configuration > Device Management >
Users/AAA > AAA Access > Authentication, and configure the following settings:
a. Check the Enable check box.
b. From the Server Group drop-down list, choose a server group name or the LOCAL database.
c. (Optional) If you chose a AAA server, you can configure the ASA to use the local database as a
fallback method if the AAA server is unavailable. Click the Use LOCAL when server group fails
check box. We recommend that you use the same username and password in the local database as
the AAA server, because the ASA prompt does not give any indication of which method is being
used.
Step 2 To authenticate users who access the CLI or ASDM, choose Configuration > Device Management >
Users/AAA > AAA Access > Authentication, and configure the following settings:
a. Check one or more of the following check boxes:
–
HTTP/ASDM—Authenticates the ASDM client that accesses the ASA using HTTPS. HTTP
management authentication does not support the SDI protocol for a AAA server group.
–
Serial—Authenticates users who access the ASA using the console port.
–
SSH—Authenticates users who access the ASA using SSH.
–
Telnet—Authenticates users who access the ASA using Telnet.
b. For each service that you checked, from the Server Group drop-down list, choose a server group
name or the LOCAL database.
c. (Optional) If you chose a AAA server, you can configure the ASA to use the local database as a
fallback method if the AAA server is unavailable. Click the Use LOCAL when server group fails
check box. We recommend that you use the same username and password in the local database as
the AAA server because the ASA prompt does not give any indication of which method is being
used.
Step 3 Click Apply.