Filter
Top Products
C-8
Catalyst 3560 Switch Hardware Installation Guide
OL-6337-03
Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
!
interface GigabitEthernet2/0/28
!
end
Step 10 These choices are displayed:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by
selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. If
you want to change this configuration or want to perform other management tasks, use one of these tools:
• Command-line interface (CLI)
• CMS from your browser
• Network Assistant from your browser
To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal
program or through the network by using Telnet. For configuration information, see the switch software
configuration guide or the switch command reference.
To use CMS, see the CMS online help. To use Network Assistant, see the Getting Started with Cisco
Network Assistant guide.