3-31
Cisco IOS XR Getting Started Guide
OL-10957-02
Chapter 3 Bringing Up the Cisco IOS XR Software on a Multishelf System
Bringing Up and Configuring Rack 0
Examples
This section contains examples for the following subjects:
• Example: Configuring and Verifying the Rack Numbers in a Single-FCC Multishelf System, page
3-31
• Example: Mapping Each Fabric Plane in a Single-FCC Multishelf System, page 3-32
• Example: Mapping Each Fabric Plane in a Two-FCC Multishelf System, page 3-32
• Example: Mapping Each Fabric Plane in a Four-FCC Multishelf System, page 3-33
Example: Configuring and Verifying the Rack Numbers in a Single-FCC Multishelf System
In the following example, rack numbers are assigned to each LCC and FCC in administration
configuration mode:
RP/0/RP0/CPU0:router# admin
RP/0/RP0/CPU0:router(admin)# configure
RP/0/RP0/CPU0:router(admin-config)# dsc serial TBA00000001 rack 0
RP/0/RP0/CPU0:router(admin-config)# dsc serial TBA00000002 rack 1
RP/0/RP0/CPU0:router(admin-config)# dsc serial TBA00000003 rack F0
RP/0/RP0/CPU0:router(admin-config)# commit
RP/0/RP0/CPU0:router(admin-config)# show running-config | include dsc
Step 11
controllers fabric plane
planeNumber
oim count 1
oim instance 0 location F
rack
/SM
slot
/FM
Example:
RP/0/RP0/CPU0:router(admin-config)#
controllers fabric plane 0
RP/0/RP0/CPU0:router(admin-config)# oim count
1
RP/0/RP0/CPU0:router(admin-config)# oim
instance 0 location F0/SM9/FM
Configures a plane to operate in an FCC slot.
• Enter this command sequence for each of the eight fabric
planes.
• Replace planeNumber with the number of the plane (0 to
7) you want to configure.
• Replace rack with the FCC rack number assigned to the
FCC that hosts the plane.
• Replace slot with the FCC slot number that supports the
fabric plane you are configuring. Valid slot numbers are
SM0 to SM23.
• The plane numbers and slot numbers are determined by
the hardware installation and cabling. The software
configuration must match the hardware configuration.
For more information, see Cisco CRS-1 Carrier Routing
System Multishelf System Interconnection and Cabling
Guide.
Step 12
commit
Example:
RP/0/RP0/CPU0:router(admin-config)# commit
Commits the target configuration to the router running
configuration.
Step 13
end
Example:
RP/0/RP0/CPU0:router(admin-config)# end
RP/0/RP0/CPU0:router(admin)#
Exits administration configuration mode and enters
administration EXEC mode.
Command or Action Purpose