Filter
Top Products
3-37
Cisco IOS XR Getting Started Guide
OL-10957-02
Chapter 3 Bringing Up the Cisco IOS XR Software on a Multishelf System
Bringing Up and Verifying the Non-DSC LCC
Flags: P - plane admin down, p - plane oper down
C - card admin down, c - card oper down
L - link port admin down, l - linkport oper down
A - asic admin down, a - asic oper down
B - bundle port admin Down, b - bundle port oper down
I - bundle admin down, i - bundle oper down
N - node admin down, n - node down
o - other end of link down d - data down
f - failed component downstream
m - plane multicast down
Plane Admin Oper Down Total Down
Id State State Flags Bundles Bundles
------------------------------------------------------
0 UP UP 0 0
1 UP UP 0 0
2 UP UP 0 0
3 UP UP 0 0
4 UP UP 0 0
5 UP UP 0 0
6 UP UP 0 0
7 UP UP 0 0
show controllers fabric connectivity all detail
The expected output should contain a series of 1s for each of the fabric planes active in the system. If a
fabric plane is administratively shut down, the output of the command remains the same. If the fabric
card is physically removed or powered down, the 1 changes to a dot (.).
RP/0/RP0/CPU0:router(admin)# show controllers fabric connectivity all detail
Flags: P - plane admin down, p - plane oper down
C - card admin down, c - card oper down
L - link port admin down, l - linkport oper down
A - asic admin down, a - asic oper down
B - bundle port admin Down, b - bundle port oper down
I - bundle admin down, i - bundle oper down
N - node admin down, n - node down
o - other end of link down d - data down
f - failed component downstream
m - plane multicast down
Card In Tx Planes Rx Planes Monitored Total Percent
R/S/M Use 01234567 01234567 For (s) Uptime (s) Uptime
-------------------------------------------------------------------------------
0/1/CPU0 1 11111111 11111111 1245608 1245608 100.0000
0/6/CPU0 1 11111111 11111111 1245608 1245608 100.0000
0/RP0/CPU0 1 11111111 11111111 1245608 1245608 100.0000
0/RP1/CPU0 1 11111111 11111111 1245608 1245608 100.0000
Bringing Up and Verifying the Non-DSC LCC
When all FCCs are up and properly supporting Rack 0, it is time to bring up and configure the next LCC
in the multishelf system as described in the following procedure: