Filter
Top Products
2-44
Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04
Chapter 2 Switch Installation
Connecting Destination Ports
Step 4 Unlock and remove the SFP module.
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver
or other long, narrow instrument to open the bale-clasp latch. See Figure 2-29.
Figure 2-29 Opening a Bale-Clasp Latch on an SFP Module Using a Flat-Blade Screwdriver
Step 5
Grasp the SFP module between your thumb and index finger, and carefully remove it from the module
slot.
Step 6 Place the removed SFP module in an antistatic bag or other protective environment.
Connecting to SFP Modules
This section describes how to connect to a fiber-optic SFP port. To connect to an RJ-45 Gigabit Ethernet
port instead of a fiber-optic port, see the “Connecting to a Dual-Purpose Port” section on page 2-46.
For instructions on how to install or remove an SFP module, see the “Installing and Removing SFP
Modules” section on page 2-42.
Warning
Class 1 laser product.
Statement 1008
1 Bale clasp
16TC
±12/24/48
0.5-3.0A
331560