Filter
Top Products
Installing a LightStream 2020 Switch 2-33
Basic LS2020 Configuration Tasks
If Your PC Has Two 1.44-MB Floppy Disk Drives
To back up each LS2020 software distribution diskette, perform the following steps:
Step 1 Insert the first distribution (source) diskette in floppy disk drive A.
Step 2 Insert a blank, formatted (destination) diskette in drive B.
Step 3 At the DOS prompt, enter the following command:
C:\> diskcopy a: b: /v
Step 4 DOS then copies the data from drive A to the backup diskette in drive B.
Step 5 At theconclusion of thefirst copyoperation, DOS asksif youwant toperform an additional
copy operation.
Step 6 Press Y and insert the next distribution (source) diskette into drive A.
Step 7 Continue copy operations until all the distribution diskettes are backed up.
If Your PC Has One 1.44-MB Floppy Disk Drive
To copy each LS2020 software distribution diskette, perform the following steps:
Step 1 Insert the first distribution (source) diskette into floppy disk drive A. (This procedure
assumes that you have configured your floppy disk as drive A.)
Step 2 At the DOS prompt, enter the following command:
C:\> diskcopy a: a: /v
Step 3 DOS reads the contents of the first source diskette into memory. When DOS prompts you
to do so, remove the first distribution diskette and insert a blank, formatted (destination)
diskette into floppy drive A.
Step 4 DOS copies the data from memory onto the backup (destination) diskette. When DOS
prompts you to do so, remove the first backup diskette and insert the next distribution
diskette in the series into floppy disk drive A.
Step 5 Alternate Step 3 and Step 4 in response to DOS prompts until you have copied the entire
set of distribution diskettes.