Filter
Top Products
3
Note The grounding lug and M4 hex-head screws with locking washers are provided in kit 69-0815-01
• One grounding wire.
The grounding wire must be sized according to local and national installation requirements. Depending on the power supply
and system, a 12 AWG conductor or larger size wire is required for U.S. installations.
• Crimping tool (must be large enough to accommodate the girth of the grounding lug when crimping the grounding cable
into the lug).
• Wire-stripping tool.
• Appropriate cables to connect the SCE8000 to the network and console terminal.
Unpacking the Cisco SCE8000 Chassis
Tip Do not discard the shipping container when you unpack the Cisco SCE8000. Flatten the shipping cartons and store
them with the pallet. You will need these containers if you need to move or ship the Cisco SCE8000 in the future.
Perform the following to check the contents of the shipping container:
• Check the contents of the accessories kit against the list of accessories in the Cisco SCE8000 Component List in the Cisco
SCE8000 Installation and Configuration Guide and the packing slip. Verify that you received all listed equipment, which
should include the following:
–
Hardware and software documentation, if ordered
–
Optional equipment that you ordered, such as network interface cables, transceivers, or special connectors
Check the modules in each slot. Ensure that the configuration matches the packing list and that all the specified interfaces are
included.