Filter
Top Products
12
Cisco uBR10-LCP2-MC28C Cable Interface Line Card for the Cisco uBR10012 Router
OL-4653-01
Installing a Cisco uBR10-LCP2-MC28C Cable Interface Line Card
Installing a Cisco uBR10-LCP2-MC28C Cable Interface Line Card
Tools and Parts Required
To remove and replace an individual cable interface line card you need the following tools and parts:
• Replacement cable interface line card (order number UBR10-LCP2-MC28C=.
• ESD-preventive wrist strap.
• Anti-static surface or anti-static bag.
• Blank line card cover (order number UBR10-MC-Covers=) if you are not replacing the card with
another card.
Note For proper cooling and airflow, you must always install a blank cable interface line card cover in a blank
line card slot. The product order number for the blank cable interface line card cover is
UBR10-MC-Cover=.
Unpacking and Preparing
Tip Make sure that you are using the ESD-preventive wrist strap.
Step 1 Open the shipping carton by cutting the packing tape along the flaps on the top of the box.
Step 2 Remove the cable interface line card.
Step 3 Place the cable interface line card on an anti-static surface or place it in an anti-static bag.
Removing a Cable Interface Line Card from the Chassis
Use the following procedure to remove the Cisco uBR10-LCP2-MC28C cable interface line card from
the Cisco uBR10012 router chassis.
To prevent alarms from activating, you must administratively shut down a cable interface line card before
hot swapping it. Refer to “Shutting Down and Restarting the Interface” in the Cisco uBR10012 Software
Configuration Guide at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/cable/ubr10k/ubr10012/index.htm
See the release notes at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/cable/ubr10k/ub10krns/index.htm
Otherwise, inform the network administrator that this portion of the network will be temporarily
interrupted. If the maintenance LED is on, you can remove the cable interface line card without affecting
system operations.