Filter
Top Products
11
Figure 7 Installing the Rack-Mount Brackets in the Middle of the Chassis for Open or Relay-Type Racks
Installing the Cable-Management Brackets
If you are rack-mounting the chassis at the rear or middle of the chassis, both rack-mount brackets and the cable-management
bracket must be installed before the chassis is installed in the rack. See Figure 8 for cable management bracket locations.
To install the cable-management bracket, complete the following steps:
Step 1 Align the cable-management bracket with the four right front threaded holes in the chassis.
Step 2 Thread four M4 x 6-mm Phillips flathead screws through the bracket and into the chassis, and use a number 2 Phillips
screwdriver to tighten the screws.
Figure 8 Location of Cable Management Bracket
1
Location of cable management bracket—rear mount
2
Location of cable management bracket—middle mount
103561
Rack-mount bracket
Rack-mount
bracket
Rack-mount
bracket
Cable
management
bracket
103571
Rack-mount
bracket
Cable-management
bracket
1 2