CBM1000 Service Manual
–
13
–
CITIZEN
2. Removing the Platen SA
(1) While pushing the pressure arm
downwardly, turn the platen bushing
by 90 degrees in either direction.
(Then, the flat surfaces of the left side
platen bushing are set in vertical.)
(2) Lift the left side platen SA to disengage
it from the U-shaped groove on the
main chassis.
(3) Pull the platen SA to the left to remove
it from the main chassis.
3. Removing the Center Frame SA
(1) Remove the four screws M3 × 6 (BT).
(2) Remove the center frame SA from the
main chassis by lifting it upward.
Note on reassembling:
Pass the connector A and B through the
holes A and B on the main chassis, re-
spectively.
Center Frame SA
M3
×
6 (BT)
Main Chassis
Center Frame SA
Platen Bushing
Platen SA
Flat Surface
Pressure Arm
Main Chassis
