Filter
Top Products
CBM1000 Service Manual
–
14
–
CITIZEN
4. Removing the Gears
(1) Remove the two screws M3 × 6 (ST)
and remove the gear holder.
(2) Remove the reduction gear and idle
gear from the gear holder, in that order.
Note on reassembling:
Apply grease (Molykote EM-10L) to the
shafts of the gear holder.
5. Removing the Auto Cutter SA
(1) Remove the four screws M3 × 6 (ST)
and remove auto cutter SA.
6. Removing the Lock Levers
(1) Remove the EXT spring-01.
(2) Pull out the ejector.
(3) Remove the lock lever-R-SA from the
right end of the lock lever-L-SA.
(4) Remove the lock lever-L-SA by pulling
it to the left.
Main Chassis
Idle Gear
Reduction Gear
Gear Holder
M3
×
6 (ST)
Auto Cutter SA
Main Chassis
M3
×
6 (ST)
Lock Lever-R-SA
Main Chassis
EXT Spring-01
Ejector
Lock Lever-L-SA