Filter
Top Products
25
Printer Operation
Media holder bar
Media holder guide
Sensor arm
Large blue-head open lever
[
Model CL-S700/CL-S703
]
Sensor arm open lever
Head unit
2. Firstly, slide the two black plastic parts of the media holder
assembly together. Ensure correct alignment of the guide with
the bar as it can only be installed in one direction.
3. Slide the roll of media over the media bar. The media guide
must be on the right side of the roll of media (as viewed from
the front of the printer) with the flat surface of the media guide
touching the roll.
Installing the Media
1. Push the large blue head-open lever to release the head unit,
and then lift the sensor arm by hand as shown below.
Media Sizes (p.23)
Setting the Media