Filter
Top Products
Chapter 3 Paper and Ribbon
35
2 Media Handling (When Using Front Sensors)
The front sensors consist of the transparent-type and reflective-type photosensors and the
position of a label or tag is detected as follows:
Transparent-type photosensor: Detects paper gap between labels and tag paper notch.
Reflective-type photosensor: Detects black line.
Note: Check that the adjustable sensor is set to ‘AJSensOF.’ (See Chapter 2.)
•
Specification of paper
For dimensions of paper gap between labels, tag paper (label paper) notch and black line,
see figure.
Minimum value mm (in) Maximum value mm (in)
A Label width 0.3 (4.65)
B Liner width 1.0 (4.65)
C Label left edge position
0.10)
D Label paper gap length 0.10
99.96
E Label length 0.10
99.96
F Label pitch 0.20
99.96
G Liner thickness 0.0025
0.0049
H Paper thickness 0.0025 0.
01
I Notch right end position 0.3
2
0.4
3
J Notch left end position
0.19
K Notch length 0.10 0.
70
L Black line right end position 0.59
M Black line left end position 0.
06
N Black line width 0.125
0.
70
Note: • Paper having both label paper gap and black line should use the paper-gap sensor.
• Fanfold should use the paper-gap sensor.
Size of paper
Label paper
Continuous paper
Notch detection Black line detection
Printable
area
Black line
OD value: 1.5 or
more
Carbon black ink
Label
Label
Label