Filter
Top Products
Disassembly
Removing the Inverter Board 2 - 17
2.Disassembly
Removing the Inverter Board
1. Turn off the computer, and remove the battery (page 2 - 5).
2. Remove any rubber covers, screws - and hinge covers - (Figure 13a), then run your finger around
the middle of the frame to carefully unsnap the LCD front panel module from the back.
3. Discharge the remaining system power (see “Inverter Power Warning” below).
4. Remove screw (Figure 13b) from the inverter, and carefully lift the inverter board up slightly.
5. Disconnect cables & (Figure 13c) from the inverter, then remove the inverter (Figure 13d) from the top
case assembly.
Figure 13
Inverter Board
Removal
a. Remove the 6 screws
and unsnap the LCD
front panel module from
the back.
b. Remove the screw from
the inverter board and lift
the board up slightly.
c. Disconnect the cables
from the inverter.
d. Remove the inverter.
1
6
7
8
9
10
11
12
13
9. LCD Front Panel
13. Inverter Board
•6 Screws
a. b.
8
13
Inverter Power Warning
In order to prevent a short circuit when re-
moving the inverter it is necessary to dis-
charge any remaining system power. To do
so, press the computer’s power button for a
few seconds before disconnecting the in-
verter cable.
1
11
2 53 4
6
7
c.
d.
12
10
9