Filter
Top Products
Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133
Email: sales@codamount.com www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual January 2006
Laminating a Print with a Sheeted Laminate
Use a sled made of a stiffer board (we
recommend Gatorfoam) that is coated and
the release paper is intact (providing a non-
stick surface).
First feed the sled into the laminator with the
release liner up so the rollers pinch it and
hold it in place. Now take a sheeted
laminate that is at least 2” larger than the
print, peel back the release liner 1/2”, put a
sharp crease in it and tack it to the sled.
Start the laminator and run it until the rollers
are on the section of the laminate that is
bonded to the sled.
Figure 20
Figure 21
Always laminate an image before you mount it. Use a slow speed setting to assure good bonding
of laminate to your print. Lamination speeds are at 1-½ to 3 on the Speed Dial.
Never stop laminating in the middle of the image or a pressure line will occur. Always use a sled
to guarantee even pressure. Use a pre-cut sheet or a roll of pressure sensitive over-laminate.
Place the print with the image facing up
under the laminate and wrap the laminate
evenly around the top roller while holding
the release liner.