Filter
Top Products
Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133
Email: sales@codamount.com www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual January 2006
Laminator Set
-
Up
When the crated machine is delivered be sure to inspect for any shipping damage
that may have occurred. If there is any damage notify the carrier and Coda, Inc.
immediately. Remove the cardboard carton and unbolt the machine from the
wooden base. Locate the laminator on a flat surface with enough space to work
with your materials. It is important to use the laminator in a clean room as dirt and
dust will stick to exposed adhesive. Adhesives and laminates perform best in a
room with a temperature of 70 degrees F or higher.
Figure 1
In the crate is a cardboard box
containing the footswitch and
pressure adjustment tool (shown in
section labeled Setting the Spring
Pressure). Place the footswitch on
the floor near the in-feed of the
laminator. You will find a
convenient location for the foot
switch once you begin working with
the laminator.