Filter
Top Products
Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133
Email: sales@codamount.com www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual January 2006
Location and Function of Controls
Figure 4
? Power ON-OFF
? Manual Mode – When power is applied and R
eset has
been pressed the machine will run at the speed set by
the Speed Dial.
? Foot Mode - When power is applied and Reset has
been pressed the machine will run at the speed set by
the Speed Dial whenever the footswitch is depressed.
? Reset – Machine will stop when the electric eye is
interrupted. The Reset must be pressed to re-activate
the machine.
? Emergency Stop – This button is located on top of the
control box. Rotate and pull up to allow the machine
to run. Push down for emergency STOP.
? SPEED – Controls the speed of the machine and has
an integrated ON-OFF position. Note: The motor
starts running when the speed is at about 2 on the
Speed Dial.