Filter
Top Products
Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133
Email: sales@codamount.com www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual January 2006
Figure 42
Coating Boards
with the Heavy Duty Roll Feed
Figure 43
Set the roller gap (1/16” less than board
thickness) as defined in previous sections
for setting roller gap, alignment and
pressure. Drape the adhesive over the
rollers then push the board in between the
rollers causing the adhesive to go with it.
Feed the board through until the trailing
edge is about in the middle of the feed tray,
then stop the laminator and butt the next
board to be coated up against it. You are
now ready to feed boards and coat
continuously.
You can use a leader board to begin this
process if you prefer.