Filter
Top Products
Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133
Email: sales@codamount.com www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual January 2006
Setting the Spring Pressure
Figure 5
To adjust the amount of
starting pressure applied
by the pressure springs, insert the adjusting tool
that came with your press into the slots in the
castle nut. To increase the amount of pressure,
rotate the nut clockwise so the spring
compresses. To decrease the amount of
pressure, rotate the nut counter-clockwise so the
spring decompresses.
The roller pressure is a measure of the amou
nt of force being applied to the material by the
rollers. It can be adjusted in two ways, by the amount of pre-
load on the pressure springs and/or
by the amount of gap. Place the pressure adjustment tool into the slots and turn to adjust the
pressure spring.
Figure 6
The pressure indicator is located on the side
post assembly and is provided as a visual
indication of the amount of pressure. The
typical setting is 1-1/8” aligned with the top
edge of the indicator. Be sure to set both
sides to the same setting.