Filter
Top Products
United States January 2, 2003
Maintenance & Service Guide
Presario 1600 Series Portable Computers
Notice | Preface | Home | Product Description | Troubleshooting | Illustrated Parts Catalog
Removal & Replacement Procedures | Specifications | Connector Pin Assignments | Battery Pack
Cable Positions
This section covers types of cables and installation instructions for hard drive
cable,
diskette drive, ZIF connectors, CD cables and speaker cable
installation.
Cables and Connectors
Most cables used throughout the unit are ribbon cables. Cables must be
handled with extreme care to avoid damage. Apply only the tension required
to seat or unseat the cables during insertion or removal from the connector.
Handle cables by the connector whenever possible. In all cases, avoid
bending, twisting, or tearing the cables, and ensure that the cables are routed
in such a way that they cannot be caught or snagged by parts being removed
or replaced.
CAUTION: When servicing this computer, ensure that cables are
placed in their proper location during the reassembly process.
Improper cable placement can damage the computer.
Cables
Use the following precautions when handling cables to avoid damage to the
cable or computer:
■ Always handle cables by their connectors.
■ Avoid bending, twisting, or pulling on the cables.
■ Apply minimum required force when seating or unseating the cables from their connectors.
■ Place the cables in such a manner that they cannot be caught or snagged by parts being
removed or replaced.
■ Handle flex cables with extreme care; they can tear easily.
CAUTION: When servicing these computers, ensure that cables
are placed in their proper location during the reassembly process.
Improper cable placement can cause severe damage to the unit.
Plastic Parts
Plastic parts can be damaged by the use of excessive force during
disassembly and reassembly. When handling the plastic parts, use care. Apply
pressure only at the points designated in the maintenance instructions.
ZIF Connectors
Compaq uses a zero insertion force (ZIF) connector for the keyboard cable to
the system board. To remove a cable from a ZIF connector, lift both corners
of the ZIF connector and slide simultaneously with constant light force. Then
remove the cable as shown below.
CAUTION: A ZIF connector and its attached cable can be easily
damaged. Handle only the connector slide when removing or
replacing a cable. Never pull or twist on the cable while it is
connected.
Removing a Cable from a ZIF Connector
Position the ribbon cable for the 3.2-GB or 4.0-GB hard drive as shown below.
3.2-GB or 4.0-GB Hard Drive Data Cable Installation
Position the ribbon cable for the CD drive as shown below.
CD Drive Data Cable Installation
Position the ribbon cable for the diskette drive as shown below.
Diskette Drive Data Cable Installation
Position the cable for the speaker assembly as shown below.
Speaker Assembly Cable Installation
privacy statement
legal notices