Filter
Top Products
Installation 2-3
■ Cable(s)
The R3000 and R3000j models ship with a non-detachable input
power cord; a 6-foot UPS/computer interface cable, Compaq part
number 295245-004; and two 10-amp, 6-foot, IEC to IEC power
cords, Compaq part number 142263-001, for load equipment power.
The R3000h, R3000h-International, and R3000h-NA models ship
with a non-detachable input power cord (the R3000h model only
ships with a detachable input power cord); a 12-foot UPS/computer
interface cable, Compaq part number 295245-004; two 10-amp,
6-foot, IEC to IEC power cords, Compaq part number 142263-001;
two 8-foot IEC to IEC power cords, Compaq part number
142263-002; and two 10-foot IEC to IEC power cords, Compaq part
number 142263-003, for load equipment power.
All models ship with a computer interface cable. The computer interface cable
is not needed for normal operation. If power management of the UPS is
desired, connect the interface cable between the UPS communications port and
the serial port on the host computer.
IMPORTANT: If the UPS does not include a power cord that is suitable for your
application, contact an authorized Compaq service representative to obtain the
appropriate power cord. Please refer to the “Precautions for Power Products” section of
the Important Safety Information (included with the UPS kit).
Before Starting the UPS
This section provides installation steps to be completed before starting the
UPS.
Determine the steps required for the application:
■ Rack-mounting the UPS
■ Connecting the UPS communications port to the host computer
■ Connecting the Remote Emergency Power Off
NOTE: Although these steps can be carried out after the UPS is installed, the UPS will
need to be powered down to safely perform these tasks.