Filter
Top Products
Regulatory Notices
C-6
greater than the voltage and current rating marked on the product. In addition, the diameter
of the wire must be a minimum of 0.75 mm²/18AWG, and the length of the cord must be
between 5 feet (1.5 m) and 6½ feet (2 m). If you have questions about the type of power
cord to use, contact your Compaq authorized service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items
placed upon it or against it. Particular attention should be paid to the plug, electrical outlet,
and the point where the cord exits from the product.
Laser Safety
All Compaq systems equipped with laser products comply with appropriate safety standards,
including IEC 825. With specific regard to the laser, the equipment complies with laser
product performance standards set by government agencies for Class 1 laser products. It
does not emit hazardous light; the beam is totally enclosed during all modes of customer
operation and maintenance.
CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug
Administration implemented regulations for laser products on August 2, 1976. These
regulations apply to laser products manufactured from August 1, 1976. Compliance is
mandatory for products marketed in the United States.
________________________WARNING___________________________
Use of controls or adjustments or performance of procedures
other than those specified herein or in the laser product
installation guide may result in hazardous radiation exposure.
____________________________________________________________
This system is classified as a Class 1 laser
product. This label appears on the laser
product.