Filter
Top Products
CRADLEPOINT CBR450| USER MANUAL Firmware ver. 3.3.0
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 59
Interfaces:
Select network interfaces to attach to this network. On the
CBR450, you must select the available Ethernet port in
order to connect to the network. You may also add a
configured VLAN interface. Double-click on interfaces shown
on the left in the Available section to move them to the
Selected section on the right (or highlight an interface and
click the + button). To deselect an interface, double-click on
an interface in the Selected section (or highlight the interface
and click the – button).
If you want more VLAN interface options, you must configure
these separately. See VLAN Interfaces in the Local
Network Interfaces section below (on this same
administration page: Network Settings → Local Networks).
Access Control:
Tune the access control settings of this network to match the
intended use. Simply select or deselect any of the following:
LAN Isolation: When checked, this network will NOT
be allowed to communicate with other local networks.
UPnP Gateway: Select the UPnP (Universal Plug and
Play) option if you want to enable the UPnP Gateway
service for computers on this network.
Admin Access: When enabled, users may access
these administration pages on this network.