Filter
Top Products
CRADLEPOINT CBR450| USER MANUAL Firmware ver. 3.3.0
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 72
7.1.3 Failback Configuration (Advanced Mode Only)
This is used to configure failback, which is the
ability to go back to a higher priority WAN
interface if it regains connection to its network.
Usage: Fail back based on the amount of data
passed over time. This is a good setting for
when you have a dual-mode EVDO/WiMAX
modem and you are going in and out of WiMAX
coverage. If the router has failed over to EVDO it
will wait until you have low data usage before
bringing down the EVDO connection to check if
a WiMAX connection can be made.
High (Rate: 80 KB/s. Time Period: 30
seconds.)
Normal (Rate: 20 KB/s. Time Period: 90 seconds.)
Low (Rate: 10 KB/s. Time Period: 240 seconds.)
Custom (Rate range: 1-100 KB/s. Time Period range: 10-300 seconds.)
Time: Fail back only after a set period of time. (Default: 90 seconds. Range: 10-300 seconds.) This ensures that the
higher priority interface has remained online for a set period of time before it becomes active (in case the connection is
dropping in and out, for example).
Disabled: Deactivate failback mode.
Immediate Mode: Fail back immediately whenever a higher priority interface is plugged in or when there is a priority
change. Immediate failback returns you to the use of your preferred internet source more quickly which may have
advantages such as reducing the cost of a failover data plan, but it may cause more interruptions in your network than
Usage or Time modes.