Filter
Top Products
Isys
®
G-Series Touchpanels Crestron TPS-12G/15G/17G-QM
Video 1 Setup Details – Video, S-Video, Component and RGB (Continued)
VIDEO 1 SETUP
SCREEN
CONTROLS
DESCRIPTION
Color Control
(Continued)
Blue
1, 2
Adjusts the amount of blue in the video signal. Available
when the RGB Color button is selected.
Overscan
3
These controls adjust the amount of video information at the
edges of the image. This part of the video picture is usually
beyond the display capabilities of the screen.
None
3
Sets the video screen so there is no overscan. The amount
of used screen area is smallest in this configuration.
Normal
3
Sets the video screen for normal overscan. This results in
more area of the screen being used.
Max
3
This sets the video screen area to the maximum. The
screen area is largest in this configuration. All video
information at the edges is visible.
Size and Position
When RGB is selected as the video source, these controls
are available when the RGB Size and Position button has
been pressed.
Calibration
Calibrates the incoming RGB signal for optimal position,
size and phase when Perform Calibration button is
pressed. In Auto Mode, the panel will attempt to find a
matching preset based on the RGB signal’s characteristics.
If it cannot find one, it automatically performs a calibration.
In Manual Mode, the panel will not attempt to find a
matching preset nor will it automatically perform a
calibration. In either mode, you can always adjust the
settings (Position, Size, Phase Coarse, Phase Fine)
manually. Settings are not saved to a preset unless the user
presses the Store Preset button.
Position
This control allows you to set the position of the video
screen on the touchpanel. The arrow buttons move the
screen along the X and Y axis.
Restore
Default
Position
Returns the video screen to its original position on the
touchpanel.
Size
Allows you to set the size of the video screen in both the
vertical and horizontal directions.
Restore
Default Size
Returns the video screen to it original size on the
touchpanel.
Phase
These controls adjust the phase of the RGB signal. Controls
are shown for both coarse and fine adjustments.
Restore
Default Phase
Returns the video signal to its original default phase.
1. Video default is zero (0) for each of the video parameters (brightness, contrast, red, green and blue).
2. Adjustment applies to the currently selected video source only.
3. These controls are available only in Video, S-Video and Component modes. In RGB mode they are
analogous to the Position, V Size and H Size controls.
44 • Isys
®
G-Series Touchpanels: TPS-12G/15G/17G-QM Operations Guide – DOC. 6415B