Filter
Top Products
CYRAQ™ 21 CyberResearch
®
Displays
4.2.6 Right Click Emulation
The TSHARC Control Panel permits users to enable Right Click Emulation, which
simulates functionality (where applicable) of a right mouse click. It works by touching
the same point on the touchscreen for a specific amount of time predetermined on the
Click Settings tab of the TSHARC Control Panel. You can enable this functionality and
define the amount of time necessary on the Click Settings tab, as seen in Figure 38.
Figure 38: Click Settings Tab
1. Click the Enable right click emulation checkbox to activate this feature.
2. The slider below the checkbox is used to determine the amount of time necessary
when holding down a touchpoint to generate the right click event.
Event Area Settings:
Since it may be difficult to touch and hold an exact point on any touchscreen for a length
of time, an event area is used to establish the size of the area in which a “hold” is
acceptable.
3. The even area should be set to at least the same size as your finger tip.
4. Click or touch “Apply” to apply your selection. “OK” to apply and exit the
control panel
58 ©Copyright 2005 CyberResearch, Inc