Filter
Top Products
Chapter 4: Command Line Interface 33
The following commands are available only to the admin user.
NOTE: When a range of outlets is used in a command and the range spans more than one PM IPDU in a daisy
chain, the range of outlets must not be specified by name. The range of outlets may only be specified by number
in this situation.
adduser
The adduser command adds one username to the internal database. A maximum of eight characters
(not case sensitive) is allowed, and a maximum of eight individual users is allowed. This command
is available to the admin user only.
Syntax
adduser <user>
Arguments
<user> username
Examples
To add a user, enter the following.
Table 4.2: Admin User (privileged) Commands
Admin User Command Admin User Command
adduser on page 33 hwocp on page 44
alarm on page 34 id on page 45
assign on page 34 name on page 48
buzzer on page 35 reboot on page 51
currentprotection on page 36 restore on page 53
dbsync on page 39 save on page 53
deluser on page 39 syslog on page 55
display on page 40 unassign on page 57
factory_defaults on page 41 upgrade on page 58
pm>adduser popper
Password:
Re-enter password:
Username/password set for user popper.
pm>