Filter
Top Products
Chapter 4: Command Line Interface 41
To view the display status, enter the following.
exit
The exit command exits the session.
Syntax
exit
Arguments
none
Examples
To exit the current session, enter the following.
factory_defaults
The factory_defaults command resets the unit to its factory configuration so that all outlets are on,
unlocked, unnamed, and no users are created. When used with a daisy chain, and no argument is
given, this command resets all units in the chain. This command is available to the admin user only.
Syntax
factory_defaults [<IPDU#>|<IPDU_ID>]
Arguments
no argument resets all PM IPDUs in the daisy chain to factory default
<IPDU#> number of the PM IPDU in the chain
<IPDU_ID> Identification string previously set by the id command
pm>display
IPDU #1: Display mode set to normal.
IPDU #2: Display mode set to 180 degrees rotated.
IPDU #3: Display mode set to show current and cycle each 2 seconds.
pm>exit
AlterPath PM
Copyright (c) 2002-2006 Avocent Corporation
V 1.9.0 Jun 21, 2006
Username: