Datalogic Scanning 6000 Barcode Reader User Manual


 
8
QuickScan 6000/6000 Plus
Where To Go From Here
Programming is easy and straightforward if you follow these steps:
1. If you are changing interfaces, first connect the scanner to the new host
using the new interface cable. Scan the interface enable bar code label
1
.
2. Scan any feature labels that are unique to the interface you are currently
programming. These interface specific programming labels immedi-
ately follow each interface selection label.
3. Turn to the Symbology section if you are going to change any bar code
symbologies or modify any symbology related features.
4. Turn to the General Features section of this guide if you wish to
change or modify any of the scanner's other features.
Once the necessary changes have been made, and you have scanned the END label,
you are ready to scan.
1 This step is not necessary for QuickScan 6000 Plus scanners, unless you require a
specific interface sub-type such as SNI OCIA or IBM sub-type 4682/92 Port E.
Interface software is automatically selected when the QuickScan 6000 Plus hardware
connection (via a new interface cable) is made.