Datalogic Scanning 90ACC1780 Barcode Reader User Manual


  Open as PDF
of 171
 
Enter configuration
ik
ik
DATA FORMAT
Exit and Save Configuration
i k
i k
54
C
HARACTER
R
EPLACEMENT
disable character replacement
i&0Nk
i&0Nk
i&0Nk
This parameter allows up to three characters to be replaced from the barcode read. These
substitutions are stored in memory. To define each
character replacement:
Read one of the following character replacement codes:
first character replacement
☞
i&0Qk
i&0Qk
i&0Qk
second character replacement
☞
i&0Tk
i&0Tk
i&0Tk
third character replacement
☞
i&0Wk
i&0Wk
i&0Wk
From the Code Identifier Table in Appendix B, read the Code Identifier for the desired code
family.
0 = character replacement will be effective for all code families.
From the Hex/Numeric Table read two characters corresponding to the Hex value which
identifies the character to be replaced. Valid values for all readers are in the range 00-FE.
From the Hex/Numeric Table read two characters corresponding to the Hex value which
identifies the new character to replace. Valid values for all readers are in the range 00-FE.
FF = the character to be replaced will be substituted with no character, that is, it will be
removed from the code.
 previous next