Filter
Top Products
44
Chapter 3
<STX>KO GPIO Output
PTX has its own GPIO configuration methods
<STX>KS Configure Scalable Font Cache Size
PTX Font cache is configured in
PRINTER CONTROL
Menu
<STX>P Enter Character Dump Mode
HexDump Mode is available in
DIAGNOSTICS
Menu
<STX>T Printhead Dot Pattern Test Label
<STX>Z Print Configuration and Dot Pattern Labels
DIAGNOSTICS -> Printer Tests
<STX>J Set Pause for each label
<STX>p Controlled Pause
These commands can be supported by using PAA to filter out the
commands, and have GPIO put the printer in Single Label Mode.
A panel-key can then be assigned by GPIO to either print the next
label (for
<STX>J
), or disable pause mode again (for
<STX>p
).
Partially Supported Commands
<STX>t Test DRAM Memory Module
<STX>w Test FLASH Module
This command tests the DRAM / Flash, and reports back to the
host. DGL always reports ‘OK’ status.