Filter
Top Products
12 Using Your Projector
Turning Your Projector On
NOTE: Turn on the projector before you turn on the source
(computer, DVD player, etc.). The Power button light blinks white
until pressed.
1
Connect the power cord and appropriate signal cables to the projector.
For information about connecting the projector, see "Connecting Your
Projector" on page 7.
2
Press the
Power
button (see "Using the Remote Control" on page 18 to
locate the
Power
button).
3
Turn on your source (computer, DVD player, etc).
4
Connect your source to the projector using the appropriate cable. See
"Connecting Your Projector" on page 7 for instructions to connect your
source to the projector.
5
By default, the input source of the projector is set to VGA-In. Change the
input source of the projector if necessary.
6
If you have multiple sources connected to the projector, press the
Source
button on the remote control to select the desired source. See "Using the
Remote Control" on page 18 to locate the Source button.
Turning Your Projector Off
CAUTION: Unplug the projector after properly shutting down as
explained in the following procedure.
1
Press the
Power
button. Follow the instruction displayed on screen to
properly turn off the projector.
NOTE: The "Press Power Button to Turn off Projector" message will
appear on the screen. The message disappears after 5 seconds or you
can press the Menu button to clear it.
2
Press the
Power
button again. The cooling fans continue to operate for
120 seconds.
3
To power off the projector quickly, press the Power button and hold for 1
second while the projector’s cooling fans are still running.
NOTE: Before you turn on the projector again, wait for 60 seconds
to allow the internal temperature to stabilize.
3
Using Your Projector