Filter
Top Products
Removing and Installing Parts 131
6
Replace and tighten the four screws to secure the hard drive.
7
Connect the power and data cables to the drive.
8
Connect the data cable to the system board.
9
Check all cables to be certain that they are properly connected and firmly
seated.
10
Replace the computer cover (see "Replacing the Computer Cover" on
page 166).
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
1 hard drive 2 power cable 3 serial ATA data cable
4 system board
connector
5 screws (4) 6 screw holes in the hard
drive bay (4)
2
4
3
1
5
6
book.book Page 131 Thursday, June 14, 2007 6:23 PM