Filter
Top Products
Specifications 109
NOTE: In you system setup (see "System Setup" on page 101), both system and administrator password options
appear as Not Set. The password feature is enabled but a password is not assigned.
13
Assign a new system and/or administrator password, as needed.
Clearing CMOS Settings
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
NOTE: This procedure does not clear or reset system and setup passwords.
1
Follow the procedures in "Before You Begin" on page 61.
2
Remove the computer cover ("Removing the Computer Cover" on page 62).
3
Reset the current CMOS settings:
4
Locate the 2-pin password (CLRPSWD) and CMOS (CLRCMOS) jumpers on the system board (see
"System Board Components" on page 65).
5
Remove the password jumper plug, then place the plug on the CLRCMOS jumper pins and wait
approximately 5 seconds.
NOTICE: The password jumper plug must be reinstalled on the password jumper pins in order to enable the
password feature.
6
Remove the jumper plug from the CLRCMOS jumper pins and place it back on the password jumper
pins.
7
Replace the computer cover (see "Replacing the Computer Cover" on page 96).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
8
Connect your computer and devices to electrical outlets, and then turn them on.
Cleaning Your Computer
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
Computer, Keyboard, and Monitor
CAUTION: Before you clean your computer, disconnect the computer from the electrical outlet. Clean your
computer with a soft cloth dampened with water. Do not use liquid or aerosol cleaners, which may contain
flammable substances.
• Use a vacuum cleaner with a brush attachment to gently remove dust from the slots and holes on your
computer and from between the keys on the keyboard.
NOTICE: Do not wipe the display screen with any soap or alcohol solution. Doing so may damage the antiglare
coating.