Filter
Top Products
98 Appendix
www.dell.com | support.dell.com
9 If you are prompted to press <F1> to continue, press <F1>.
10 After the Microsoft Windows desktop appears on your computer, shut down the
computer (see page 30).
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then
unplug it from the network wall jack.
11
Turn off any attached devices and disconnect them from their electrical outlets.
12 Disconnect the power cable from your computer, and then press the power button to
ground the system board.
13 Remove the computer cover (see page 71).
14 Remove the password jumper.
Attach the jumper to only one pin so that you do not lose it.
15 Replace the computer cover (see page 90).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
16 Connect your computer and devices to electrical outlets, and turn them on.
17 If you are prompted to press <F1> to continue, press <F1>.
Replacing the Battery
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 9.
A coin-cell battery maintains computer configuration, date, and time information. The
battery can last several years.
If you have to repeatedly reset time and date information after turning on the computer,
replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the 3-
V CR2032 battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer’s
instructions.
1
Record all the screens in the system setup program (see page 95) so that you can
restore the correct settings when your perform step 7.
2 Open the computer cover (see page 71).
3 Locate the battery socket (see page 74).