Filter
Top Products
Using the Stapler
Dell 7330 Mono Laser Printer
4-50
Using the Stapler
Stapling Options
Several stapling options are available in the Dell 7330 Mono Laser Printer driver:
■ No Stapling: This is the default option. When selected, prints are not stapled.
■ 1 Staple: Inserts one staple in each set of copies.
■ 2 Staples: Inserts two staples in each set of copies.
■ Advanced Stapling: Provides options for controlling staple placement.
To select a stapling option in a supported driver:
Note: You can use the control panel or EWS to set the default stapling option.
Low Staples Behavior
When the printer detects a low quantity of staples, a 15 minute delay is started during which
three things can happen:
■ The print job can be resumed without staples.
■ The user can refill the staple cartridge, and then continue the print job.
■ The print job can be cancelled.
If no action is taken by the end of the 15 minutes, the print job will resume, run the staples out,
and continue to print without stapling.
Operating System Steps
Windows 2000 or later On the Paper/Output tab, select an option from the Stapling
drop-down list.
Mac OS X (version 10.3
and higher) driver
In the Print dialog box, select Finishing Options from the drop-down
list, and then select the stapling option.