Filter
Top Products
IPv6
Dell 7330 Mono Laser Printer
3-27
Automatic Address Assignment
Addresses can be assigned automatically when a router is found that offers one or more
prefixes. Automatically assigned addresses are routeable. Each router-supplied prefix is
combined with the Interface ID to create an address. The use of router-supplied prefixes is
enabled by default.
To enable/disable automatic address assignment, use one of the following options:
■ The printer’s control panel
■ Embedded Web Server
Enabling/Disabling Automatic Address Assignment with the Control Panel
To set the Interface ID on the control panel:
1. Select
Printer Setup, and then press the OK button.
2. Select
Connection Setup, and then press the OK button.
3. Select
Network Setup, and then press the OK button.
4. Select
TCP/IPv6 Setup, and then press the OK button.
5. Select
Auto Assign, and then press the OK button to turn Auto Assign On or Off.
Enabling/Disabling Automatic Address Assignment with the Embedded Web Server
To set the Interface ID with EWS:
1. Launch your web browser.
2. Enter your printer’s IP address in the browser’s Address field.
3. Click Properties.
4. Select the Protocols folder on the left navigation panel, and then click TCP/IP.
5. Click the TCP/IP (v6) button.
6. Select/deselect Use router supplied prefixes.
7. Click the Save Changes button at the bottom of the page.