Filter
Top Products
Printing on Specialty Media
Dell 7330 Mono Laser Printer
4-37
2. Insert the transparencies (long-edge feed preferred) into Tray 2, 3, 4, or 5.
Note: Do not load paper above the fill line inside the tray.
3. Adjust the paper guides to the size of the transparencies.
4. If prompted on the control panel, press the OK button to accept the paper size and type
that are shown. If you have changed the paper size or type, do the following:
a. Select
Change setup, and then press the OK button.
b. Select
Transparency, and then press the OK button.
c. Select the paper size, and then press the OK button to save your selection.
5. In the printer driver, select either Transparency as the paper type or the tray you loaded as
the paper source.
7330-143